Clirik CLUM Vertical Roller Mill Maintain Tips

The use of the vertical roller mill greatly facilitates the user's process of beneficiation. Vertical roller mill users also need to master some operating points during the use of the equipment. For example, what is the maximum diameter of the ore that can be produced by the equipment, and what range of the feeding speed of the feeder should be controlled. These are the details that everyone needs to pay attention to during use. These details can not only help everyone to obtain better production efficiency, but also effectively extend the service life of the vertical roller mill.

Vertical Roller Mill Introduction

The vertical roller mill has its unique role and position in the mineral powder grinding industry. It adopts novel grinding technology to make the ore materials after grinding fine and uniform, with concentrated particle size distribution, and the fineness can reach 3000 mesh. Therefore, the grinding effect of the vertical roller mill cannot be replaced by Raymond mills and other equipment.

Vertical Roller Mill Maintain Methods

1. When the new vertical roller mill is put into production, check the looseness of the connecting bolts everywhere, especially the looseness of the bolts of the main machine and the main machine grinding roller device. In the process of use, a special person should be assigned to take care of it, and the operator must have certain technical knowledge to operate the equipment. Before the vertical roller mill is installed, the operators must be trained as necessary to enable the operators to better understand the installation process and precautions.

2. The grinding roller device of this equipment should be replaced with parts after the use time exceeds 500 hours. When replacing the grinding roller, the quincunx cover on the quincunx frame should be marked with a mark, and the assembly is not allowed to be replaced during assembly. And all parts in the equipment must be cleaned, and damaged parts should be replaced in time. The fueling tools can be divided into two modes of manual fueling pump and grease gun. When the bearing is found to be overheated, immediately remove and clean the surrounding accessories.

3. Every time the machine works for a period of time, the main vertical roller mill grinding roller device should be removed and cleaned, and the dirty oil, dust, etc. inside should be cleaned, and the seal should be replaced if it is broken. If the inside is too dirty or two or three cleaning cycles have passed, the bearing should be removed and cleaned. When the bearing is found to be overheated, immediately remove and clean the surrounding accessories.

The user of the vertical roller mill should also provide regular maintenance and routine maintenance for the equipment. Due to the long working hours and heavy workload of such equipment, the consumption of equipment parts will be relatively large. In order to further extend the service life of the equipment, we recommend that you regularly replace parts or provide lubricating oil for the equipment during use. This will not only ensure the normal production of the ultra fine vertical roller mill, but also to a certain extent Help companies save the cost of replacing equipment.