HGM80 Ultra Fine Grinding Mill Used in Waste Tire Powder Processing

Refined carbon black after cracking of waste tires

1. Refined carbon black is reused to make car tires, fan belts and printer toner.

2. Regenerated carbon black can be refined to nano-level quality, replacing expensive virgin carbon black, allowing manufacturers to provide cheaper alternatives and alternative products.



2021 is a special period when the epidemic is raging. After being introduced by peers, Malaysia's leading domestic environmental protection company contacted Shanghai Clirik and expressed its willingness to cooperate on expanding the production of carbon black refined powder.

At that time, there was a lack of offline inspection conditions. Due to the recognition of the Clirik brand and the recommendation of local colleagues, the two parties subscribed to an HGM80 series ultra fine grinding mill production line after only a few video conferences. 30 days later, a brand new small carbon black production line was

Clirik carbon black production line technical services

At Clirik, the end of the subscription link between the two parties never means the end of the service link:

With rich production experience, the after-sales service team keeps records of each customer's situation to ensure timely response under any circumstances. In daily communication, the after-sales technical team adheres to the service concept of "continuing the entire equipment life cycle" and rushes to the production site immediately after the epidemic is over to fully optimize and upgrade the equipment.

Optimization content: Adaptive debugging of equipment parameters, unmanned configuration, feed fineness and other data.

1. Upgrade and transform equipment installation.

2. Adjust relevant data parameters.

3. The fan is equipped with a frequency converter to enable intelligent high- and low-voltage wind operation.

Establish a long-term mechanism:

1. Provide detailed guidance to local company equipment managers on operational requirements and material feed fineness requirements.

2. Record the operation status, wearing parts replacement cycle and other information in detail, and prepare a plan.

Clirik-Professional waste tire carbon black production equipment

The Clirik HGM80 model production line is a small milling production line with a total length of only 15 meters, which can ensure that the fineness of the finished product is adjustable between 200-2500 mesh, and the 2μm content is nearly 70%. After optimization and upgrading, while maintaining high-quality output, production capacity has been further increased by 3-5% compared with before.

As a result, a single HGM80 equipment production line, with a host power of only 75KW, can provide an hourly output of more than 1 ton, and the annual output can exceed 5,000 tons. Compared with other types of grinding mills, the output has nearly doubled under the same generator power level; in terms of the fineness of the finished product, energy consumption has been reduced by more than 30%.

Small models create large production capacity. The customer company is very satisfied with the equipment and praises: "The production capacity of this carbon black grinding production line alone is enough to adapt to the production capacity of our two tire pyrolysis production lines!"

Equipment list used in carbon black production line

Production line	HGM-80 ultra-fine grinding mill production line
Processing materials	carbon black
Finished product particle size	200-600 mesh
Annual production capacity	6600 tons
Equipment configuration	1 HGM80 host, 1 powder separator, 1 fan, 1 hammer crusher, 1 bucket elevator, 1 screw feeder, 2 discharge valves, 1 air compressor , 1 pulse dust collector.
Usage of finished products	carbon black powder

 

Customer on-site demonstration of carbon black production line